المنتجات

EKT - D 425

The outer surface of the device is made of galvanized steel, painted with electrostatic paint to protect against rust. The inner surface is produced of stainless steel.

The device operates with 195-230 V/50 Hz network voltage.

The door of the device has double thermal glazing, it can be locked and has magnetic seal rings. Thus, it provides an opportunity to trace the stocks. The deep freezer door section has polyurethane insulated block-door system.

There is a plastic covered wire shelves in the device that can be adjusted according to the desire of the user. The deep freezer section has Cr-Ni shelves system.

Operates between 0/+15 degrees and it is set to +4 degrees. The deep freezer section is set at -20 C degrees.

Provides equal temperature distribution with the strengthened fan system it contains.

Works smoothly and quitely.

The lightening of the inner cabin of the device is carried out with LED lightening.

A user-friendly digital control panel with a micro processor has been used on the device. This system can keep the data in memory for 30 days.

There is a USB Output which has got 10 years recording memory that provides the transmission of the device temperature information to electronic environment if required.

The thermostat at the control panel of the device can make measurements with 0.1 degree sensitivity.

There is an accumulator system charged automatically at the control panel of the device. This system provides that at possible electricity cut offs the digital control panel and the thermal printer continue working for 24 hours.

While the refrigerator is working the device gives alerts with the visual and audio signal when the lower and upper temperature limits are exceeded, the door of the device is left open, and there is electricity cut off or low voltage problems.

The cooling system and the insulation system of the device do not contain CFC gas that is harmful for OZONE.

There are two wheels with stoppers and two regular wheels on the device to provide easy portability.

All medical devices produced by Emsaş A.Ş. are guaranteed for 2 years.

As per the request of the user, a thermal printer can be installed at the device. The numerical and graphical printout of the data recorded with the thermal printer can be taken.

All our products are produced in line with the ISO 9001:2008, TSE service place competence certificates. The device has CE certificates and barcode.